Standard for rubber waterstop: in the process of engineering design and construction selection, the width and thickness of CB rubber waterstop shall be determined according to the following conditions:
When the water pressure is less than 4m and the horizontal and vertical deformation does not exceed 10mm, the width and thickness of the waterstop should not be less than 200mm;
When the water pressure is 4-8M and the horizontal and vertical deformation does not exceed 30mm, the width and thickness of CB rubber waterstop shall not be less than 300mm and 6mm;
When the water pressure is greater than 8m and the horizontal and vertical deformation exceeds 30mm, the width and thickness of CB waterstop shall not be less than 350mm and 8mm;
The water pressure shall not be greater than 8m, and the horizontal deformation shall not exceed 20mm. When there is no vertical deformation, the width and thickness of CB waterstop shall not be less than 200mm and 5mm.
rubber waterstop
Back attached Waterstops are used for many purposes. Back attached Waterstops are used for many purposes, including the following:
It is suitable for sealing, blocking, leak proof and weather proof purposes. It is suitable for both indoor and outdoor, with remarkable anti-seepage and leak proof effect.
Bonding various interior decoration of automobile, including metal, fabric, organic fabric and plastic.
Engage the gasket on the heating and cooling equipment.
Add ribs without screw holes, nameplates and painted plastic materials on the metal surface.
Seal the window on the oven door, the flue, pipe joint and channel door on the gas appliance.
Provide immediately formed leak proof pads for gearbox, compressor and pump.
The back attached waterstop seals the cabin and window.
Sealing of glass window of trailer and truck cab.
Bonding and sealing equipment components.
Form an anti-wear coating.
Inlay and fill thin metal sheet laminations, pipe networks and equipment casings.
